The antenna tilt configuration files presented below contain information needed by the RET controllers to identify which antenna type it is connected to. It also contains the necessary data about the antenna in order to set the correct tilt angle.

Antennas delivered with pre-mounted RET units already have the correct antenna tilt configuration file installed.

The antenna tilt configuration files are used for RET controllers to make it possible to calibrate the antennas. It programs the tilt range for each antenna so the antenna can be accurately calibrated and tilt to the proper downtilt angle. The AISG HEX files are for using with our Powerwave Master Control Unit (MCU) when antennas were purchased separately from the RET motors. If using a Kathrein controller and loading our antenna tilt configuration files, you will instead need to use the AISG BIN files. For Ericsson controller, use the legacy XML format files. For AISGv2.0, use the XML AISGv2.0 files. The SIEMENS files support the legacy Siemens controller. If using another vendor’s antennas and motors, please contact that vendor for their antenna tilt configuration files.

AISG v2.0:
       AISGv2.0_BIN_20121111.rar
       AISGv2.0_HEX_20121111.rar
       
AISGv1.1:
      AISGv1.1_BIN_20100910.zip
      AISGv1.1_HEX_20100910.zip

AT&T:
      AT&T P65-90 ACF 052011.zip

Ericsson XML Format:
      XML Ericsson AISGv2.0_20111005.rar
      XML Legacy Ericsson_20100910.zip

Siemens Legacy Protocal:
      Siemens_20100910.zip